Close

(Old) Blog Bootstrap (of my previous blog)

This was the first post in my previous blog. The start-up of this present blog is here: A New Beginning – Again. Sorry for the confusion :=)

Linux version 2.6.26-rc2-omap1 (gcc version 4.2.2) #1
CPU: ARMv7 Processor [413fc082] revision 2 (ARMv7), cr=00c5387e
Machine: OMAP3 Beagle Board
Memory policy: ECC disabled, Data cache writeback
OMAP3430 ES2.0
SRAM: Mapped pa 0x40200000 to va 0xd7000000 size: 0x100000
CPU0: cache: 768 bytes, associativity 1, 8 byte lines, 64 sets
Kernel command line: root=/dev/mmcblk0p2 rootdelay=2
console=ttyS2,115200n8 noinitrd rootfstype=ext3 ip=off
Clocking rate (Crystal/DPLL/ARM core): 26.0/332/500 MHz
IRQ: Found an INTC at 0x48200000 (revision 4.0) with 96 interrupts
OMAP34xx GPIO hardware version 2.5
PID hash table entries: 512 (order: 9, 2048 bytes)
omapfb: Framebuffer initialized. Total vram 2359296 planes 1
omapfb: Pixclock 48000 kHz hfreq 44.7 kHz vfreq 57.7 Hz
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
serial8250.0: ttyS0 at MMIO 0x4806a000 (irq = 72) is a ST16654
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem).
smsc95xx 1-2.1:1.0: eth0: register ‘smsc95xx’ at usb-ehci-omap.0-2.1, smsc95xx USB 2.0 Ethernet
EXT4-fs (mmcblk0p2): re-mounted. Opts: errors=remount-ro

Spritux 2.6 omap ttyO2
Welcome to the Lucuratory!

omap login: root
password:

/root>remove -type blog -name -vitruvimente -comment ‘years 2007-2011, old and archived’
Done.

/root>init -type blog -name lucubratory
Done.

Welcome to your new blog and Enjoy!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close